Refined title: 7.5inch E-Ink Display HAT, 800x480 Pixel Black/White Two-Color SPI E-Paper Screen for Raspberry Pi and Jetson Nano

This 7.5-inch E-Ink display HAT for Raspberry Pi features an 800×480 resolution and an SPI interface. Boasting advantages such as ultra-low power consumption, wide viewing angle, and clear display without electricity, it is an ideal choice for applications like shelf labels and industrial instruments.

The key features of this display include: 1. No backlight, allowing the last displayed content to remain visible even when the power is turned off. 2. Ultra-low power consumption, as power is only required for refreshing the display. 3. Standard Raspberry Pi 40-pin GPIO extension header, supporting Raspberry Pi series boards and Jetson Nano. 4. SPI interface, enabling connectivity with other controller boards like Raspberry Pi, Arduino, and Nucleo. 5. Onboard voltage translator, compatible with 3.3V and 5V MCUs. 6. Comprehensive development resources and manuals (examples for Raspberry Pi, Jetson Nano, Arduino, and STM32).

The display's technical specifications are as follows: 1. Operating voltage: 3.3V to 5V 2. Interface: SPI 3. Outline dimension: 170.2mm × 111.2mm 4. Display size: 163.2mm × 97.92mm 5. Dot pitch: 0.205 × 0.204 6. Resolution: 800×480 7. Display color: black and white 8. Grayscale: 2 9. Full refresh time: 5 seconds 10. Refresh power: 38mW (typical) 11. Standby power: less than 0.017mW 12. Viewing angle: greater than 170 degrees

The interface pinout is as follows: - VCC: 3.3V to 5V power supply - GND: Ground - DIN: SPI MOSI pin - CLK: SPI SCK pin - CS: SPI chip selection, low active - DC: Data/Command selection (high for data, low for command) - RST: External reset, low active - BUSY: Busy status output, low active

For more information, please visit the online development resources and user manual at //bit.ly/3FWYfyo.

The package includes a 7.5-inch e-Paper, an e-Paper Driver HAT, a Raspberry Pi screws pack (2 pcs), and a 20cm PH2.0 cable.

product information: